What Planned Industrial Roof Maintenance Can Uncover
A planned maintenance visit is not just a clean and a tick-box. It is often the only time someone gets a proper look at the gutters, flashings and cladding on an industrial roof before the next spell of wet weather. A recent industrial roofing maintenance visit we carried out on a Midlands industrial unit is a good example of what that can turn up.
What we went to do
The job was a scheduled maintenance visit. The agreed scope was practical and specific:
- replace the flashing to the rear fire-escape door
- replace the front roller-door flashings
- replace front elevation cladding sheets where previous signage had left holes in the wall
- clean out the front and rear gutters
- clean the roof and roof lights
All of that was completed on the day. The flashings and cladding sheets were left in good order, and the roof and roof lights were cleaned down. Those are the sorts of small, planned cladding repairs that stop water getting in at doors and elevations without waiting for a full refurbishment.
What the gutters revealed
Once the gutters were cleaned out, the real problem showed. Both the front and rear gutters were rotten. The sole was corroded right through in places, with clear perforations, and the joints and fixings were heavily corroded. Standing water was visible in the gutters.

That is not a job for another clean or a patch of sealant. A temporary seal was applied after the corroded holes were cleaned back to bare metal with a wire brush wheel — useful only to reduce water getting through until a proper repair is done. It is not a lasting fix.
The urgent recommendation was a Fatra gutter lining to the front and rear gutters, installed under the roof sheets so water cannot get under the liner. A Fatra single-ply lining comes with a 25-year system warranty. Where a GRP lining suits the job better, that carries a 5-year warranty. You can read more on our gutter lining page.
At this site, the neighbouring gutters were also in poor condition. If one run has rusted through, it is worth checking the units either side before the same leak appears next door.

Other items to keep an eye on
Alongside the urgent gutter finding, several roof items were rated for monitoring and should be addressed in the near future rather than left until they fail:
- end lap and cut edge treatment
- fixings
- ridge seals and foam fillers
- roof lights
None of those needed emergency action on the day, but they are the sorts of medium-risk defects that get worse through a wet winter if they are ignored. Recording them on a planned visit means they can be priced and programmed properly, instead of turning into a call-out when water is already inside the building.
Why planned visits matter before winter
If this unit had only been looked at when a leak appeared, the gutters would already have been discharging through the sole. Because the visit was planned, the flashings and cladding sheets were put right at the same time, the gutters were cleaned, the corrosion was photographed, and the lining recommendation was clear before the worst of the winter weather.
That is what planned preventative maintenance is for. Regular gutter maintenance keeps debris out of the outlets and underground drainage, and it is also when we spot corrosion, failed flashings and worn cladding before they become leaks over stock, plant or office space. This visit was documented with a written report and photographs.
If water is already coming in, we offer free leak inspections, usually next day. Where the whole roof needs a closer look, we can arrange a site survey — see our industrial roof and cladding site surveys and roof leak investigation pages. Where cladding sheets, flashings or elevations need putting right, that work sits naturally with our industrial cladding services.
Book a maintenance visit
We look after commercial and industrial roofs across the Midlands and the North West, and further afield on request. If you want a planned maintenance programme, a gutter clean, or a clear report on what your roof needs before winter, get in touch or call ABS Cladding Services on 01902 653322.
Request a Site Survey Send an Enquiry
No obligation. Just tell us about your building and we’ll be in touch.
IPAF · PASMA · CSCS · CITB · KeeLine, Kingspan, Euroclad and Alwitra approved installer
